43.3" L Overhead Drip Cap Guard for Exterior Door & Window,Rain Diverter/Deflector,Drip Edge,Anodized Aluminum 1pc Silver

Our Door Bottoms Overhead Rain Top Drip is designed with an extended and wider length of 110cm (43.3 inches), which can fit most of the doors and windows, and is mainly used in home doors and windows, camper vans, motorhomes, stores and so on. The width reaches 8cm(3.15 inches), which is wider than other models for better rain protection. Pre-drilled holes, we set up 6 screw holes for you on Overhead Rain Top Drip Edge, meanwhile we provide 6 x 3cm long screws and 6 x expansion screws. Save you a lot of time. Anodized aluminum material, rust and corrosion resistant. The new rolled edge exterior design allows rainwater to flow out to the sides along the rolled edge area of the drip cap, preventing it from dripping on people entering and exiting the doorway.

• Brand new product, we widened and heightened the raindrop cap, the width reached 8 cm/3.15inch, the height of the position for tightening and fixing is 2 cm/0.79inch, which is wider and higher than other brands, more conducive to installation and rain protection. The length is 110 cm/43.3inch.High-quality materials. The raindrop cap, rain baffle and weatherproof strip on the top of the outer door are made of anodized aluminum, and the 1.4mm thick material is sturdy and durable.
• Prevent rain from penetrating into doors and windows. When encountering rainy weather, rain will enter your windows and doors along the wall, causing moisture and polluting the appearance. When you use our raindrop cap, it will solve this problem well.
• Prevent wooden door frames, window frames and thresholds from rotting. Long-term rain erosion will cause wooden door frames, window frames and thresholds to rot and damage. You can install raindrop caps on the top of doors and windows, which can divert rainwater well, and rainwater will not penetrate into your doors and windows, protecting your door frames and window frames.
• New Rolled Edge Design: At the same time, we have adopted a rolled edge design for the drip cap, so that when the rainwater runs down the drip cap, the rainwater will run down the sides along the rolled edge, preventing the rainwater from dripping from the front on the body of the person who enters or leaves the door.
• Easy to use. We have 6 reserved holes in the raindrop cap and equipped with 6 3cm long screws for tightening and fixing. It can be cut to the length you need with a hacksaw. After installation, it is recommended to seal with caulking sealant (caulking sealant is not provided)